| How I make Flipper's | ||
|
|
Part 2 | |
|
Page 8 |
||
| Ok, I had a good time on my road trip to Boise and the supplies I needed to finish this knife have arrived so let's get on with the program. | ||
| Ok I missed some small steps but here I have the detent hole drilled, I use a solid carbide drill to drill into the hardened blade. |
|
|
| Installed a detent ball. |
|
|
| Here is a little video of me checking to see how the detent works after drilling and installing a temporary ball. | ||
| I've back drilled the 1st bolster from the liner and glued it to the other bolster to transfer the holes and so they can be profiled together. |
|
|
| Tapping the holes for the screws that will secure the bolsters. |
|
|
|
|
|
